Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Instrukcja Użytkownika Pobierz pdf (Strona 14)

IP MODULE

Technical Guide

CommLink Conﬁ guration

Changing the IP Address of the

CommLink

Follow the instructions below to set your IP Module’s IP address.

Be sure you have conﬁ gured your PC’s IP address as described

on page 13.

1.) Run the Prism 2 program, open the Job Sites Window,

and type the default IP address 192.168.1.25 in the Node

IP Address ﬁ eld. See the Prism 2 Technical Guide if

needed for further instructions. To access the IP Module

web page, click on the

<Communications> tab and then

click

<CommLink IP Web Settings> (see below).

The IP Module web page should appear as shown in

Figure 14.

2.) Enter a password if required. By default, the

CommLink does not have a user name or password.

Figure 14: CommLink’s IP Module Home Page

Figure 15: CommLink’s IP Module Network

Conﬁ guration Settings

4.) Under IP conﬁ guration, select the radio button

in front of the option

<Use the following IP

conﬁ guration> and type in the IP address,

Subnet Mask, and Default Gateway as provided

by the jobsite IT staff.

NOTE: Be sure all other settings are set to default as shown

in Figure 15.

5.) Click <OK> at the bottom of the Network Settings

Screen once the changes have been made.

3.) Click

<Network Conﬁ guration> found in the menu

bar on the left side of the web page.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Instrukcja Użytkownika Strona 14