Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Instrukcja Użytkownika Pobierz pdf (Strona 10)

IP MODULE

Technical Guide

CommLink IV with IP Module Connections and Wiring

Figure 6: CommLink IV with IP Module Connection & Wiring

24 VAC Power

If Desired A 24 VAC Transformer

(Not Included) Rated At 12 VA

Minimum May Be Used Instead

Of The Supplied Power Pack.

Use 18 Gauge Minimum

2 Conductor Wire Between The

Transformer & CommLink IV

Terminals.

120 to 24 VAC Power Pack

(Included With CommLink IV)

Connect To 120/1/60 Duplex

Receptacle (By Others).

CommLink IV with IP Module

CommLink IV with IP Module Connection & Wiring

NOTES:

1.) Use 18 Gauge Minimum 2 Conductor Twisted Pair With Shield Cable Belden #82760

(Not Included) Or Equivalent To Connect The CommLink IV To A MiniLink Or MiniLink PD

On The Network Loop Or To Controllers On A Local Loop.

2.) The CommLink IV Cannot Communicate With The Control System Through Its

Ethernet Port And USB Port At The Same Time.

3.) All Wiring Must Conform To Applicable Federal, State & Local Electrical Wiring Codes.

18 Gauge 2 Conductor

With Shield (Not Included)

See Note 1.

Connect To A

MiniLink PD, MiniLink

Or Other Controller As

Required By Your

Specific System

Wiring Instructions.

See Note 1.

MODEM

RS-232

Serial #

COMPUTER

USB

10/100

ETHERNET

DIAG

24V

GND

485 LOOP

POWER

Reset

Default

Values

ACT LNK

USB

Config

Normal

When Connecting Directly To Your

Computer, Use The 10

Crossover

Prefabricated Ft.

Long CAT5 Ethernet Cable

(Included).

Connect Directly To Your Computer

(Crossover CAT 5) Or Connect To An

Available 10/100 BaseT Port On Your

LAN (Standard CAT 5).

WARNING! Do Not Have Your Ethernet Connection

And USB Connection Connected At The Same Time.

This Could Cause Unreliable Communications.

Supplied With CommLink

But Not Required For IP

Module Installation. See

Note 2.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module