Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Instrukcja Użytkownika Pobierz pdf (Strona 12)

Remote Link II Technical Guide

Operator Interface

Prism Setup Instructions for Remote Dial-Out

Prism Setup for Remote Dial-Out

1. Open your Prism software.

2. Click on the <Key> button and type in your

level 3 passcode (default “sm”).

Click <Done>.

3. If Prism is online, click

<Communications> and

then click <Go Ofﬂ ine>.

4. Click on the

<Edit Jobsite> button to enter

jobsite information.

5. Click on an empty location. Type in a job name and

press

<Enter>.

6. Double-click in the Port location on the same line as

the job name. The PortCtl Class Properties Window

will pop up.

7. Click on the down arrow on the Port pull down box

and select the COM port that the Remote Link II is

using. If using a USB connection, this port number is

the one you should have found in the Device Man-

ager. If using a serial connection, the COM port will

be COM1 or COM2. Click

<Apply> and then click

<OK>.

8. In the Job Site Window’s CommLink ﬁ eld, type in

the number “1” if the CommLink is a single loop

CommLink; otherwise, leave the default “0” for

multiple loop. Press

<Enter>.

9. In the Job Site Window’s Phone Number ﬁ eld, type in

the phone number of the remote job you want to

connect to and press

<Enter>. Click <Done>. The

Job Site Window will close.

10. Click on the

<Dial-Out> button, located at

the top of the Prism Screen, to begin

dialing. The Dialing Status Window should

appear. Verify that you are calling the correct

jobsite.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Instrukcja Użytkownika Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr