Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Instrukcja Użytkownika Pobierz pdf (Strona 14)

CommLink IV Technical Guide

Operator Interface

CommLink IV LED Descriptions

Figure 3: CommLink IV LED Display

STATUS

RX-USB

TX-USB

LOOP

TX-CPU

RX-CPU

ACT-LAN

LNK-LAN

CONTROLS

CommLink IV

www.wattmaster.com

CommLink IV LED Descriptions

LOOP - Indicates communication activity on local controller

network. This LED ﬂ ickers when data is exchanged

with the controller network.

TX-USB - Indicates transmitted data status of USB

connection. This LED only ﬂ ashes when your

CommLink is connected to a computer and data is sent

to Prism from the CommLink via USB.

RX-USB - Indicates received data status of USB connection.This

LED only ﬂ ashes when your CommLink is connected to a com-

puter and data is sent from Prism to the CommLink via USB.

TX-CPU - Indicates transmitted data status. This LED only ﬂ ashes

when your CommLink is connected to a computer and data is sent

to Prism from the CommLink using USB or Ethernet.

RX-CPU - Indicates received data status. This LED only ﬂ ashes

when your CommLink is connected to a computer and data is sent

from Prism to the CommLink using USB or Ethernet.

ACT-LAN - Indicates activity on the local area network. This LED

ﬂ ashes on when LAN is transmitting and receiving data and is

only operational when the IP Module Kit is installed.

LNK-LAN - Indicates local area network is connected. This LED is

on when connected to LAN and is only operational when the IP

Module Kit is installed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Instrukcja Użytkownika Strona 14