Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Instrukcja Użytkownika Pobierz pdf (Strona 11)

CommLink IV Technical Guide

Operator Interface

6. Double-click in the Port location on the same line as the job

name. The PortCtl Class Properties Window will pop up.

7. Click on the down arrow on the Port pull down box and se-

lect the COM port number that the CommLink IV is using.

Click <Apply> and then click <OK>.

8. In the Job Site Window’s Baud Rate ﬁ eld, type in the baud

rate 19200 and press <Enter>.

9. If you are using a single loop CommLink, type a “1” in the

CommLink ﬁ eld in the Job Site Window and press <En-

ter>

. For all other conﬁ gurations, leave “0” in the ﬁ eld.

10. Click <Done>.

11. Click <Communications> again and select <Go On-

Line>

Prism Setup Instructions

Prism Setup

1. Open your Prism software.

2. Click on the <Key> button and type in

your level 3 passcode (default “sm”).

Click <Done>.

3. If Prism is online, click <Communications> and then

click <Go Ofﬂ ine>.

4. Click on the <Edit Jobsite> button to enter

jobsite information.

5. Click on an empty location. Type in a job name and press

<Enter>.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Brak uwag

Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Instrukcja Użytkownika Strona 11